FF-2-P | Siemens NX - FreeformSwept, create a Y-Pipe in a few minutes This exercise shows the typical work steps for creating a Y-pipe with the Swept command and modelling the flanges. It is the practical exercise for the FF-2 learning video. It shows once again the...
pipe
FF-1-P
FF-1-P | Siemens NX - FreeformSwept, create an elbow This exercise shows the typical work steps for creating a pipe elbow with the Swept command and modelling the flanges. It is the practical exercise for the FF-1 learning video, so it does not teach you any new...