FF-3 | Siemens NX - FreeformSwept, orientation methods The Orientation option controls the orientation of the cross-section to the guide curve.Similar to how a spatula is repeatedly oriented differently when drawing, the different options create different surfaces.The...
exercise
FF-3-P2
FF-3-P2 | Siemens NX - FreeformSwept, construction of a turbine casing The cross-section of the opening follows a spiral helix. The cross-section is also scaled using a further curve. And the spine option helps with the perfect alignment of the surfaces. And so the...
FF-2-P
FF-2-P | Siemens NX - FreeformSwept, create a Y-Pipe in a few minutes This exercise shows the typical work steps for creating a Y-pipe with the Swept command and modelling the flanges. It is the practical exercise for the FF-2 learning video. It shows once again the...
FF-1-P
FF-1-P | Siemens NX - FreeformSwept, create an elbow This exercise shows the typical work steps for creating a pipe elbow with the Swept command and modelling the flanges. It is the practical exercise for the FF-1 learning video, so it does not teach you any new...
FF-3-P1
FF-3-P1 | Siemens NX - FreeformSwept, to build a propeller A propeller, also known as a Kaplan turbine, is like a spiral staircase. This also has a flat pitch on the outside, which becomes steeper and steeper to the inside. The blades of the propeller are shaped in...