extrude

B1P-5

B1P-5 | NX Tutorial Modeling Arcs in the sketch, the Extrude command and Fine threadThe Extrude command ... The exercise has the following main points: The outer contour, like the long hole, consists of degrees and arcs that can be created with the Profile command ......

B1P-5-A

B1P-5-A | NX Tutorial Modeling Arcs in the sketch, extrude, hole and edge blendWelcome to the second "Test yourself"! This exercise does not teach any new content, but rather gives you the opportunity to review and consolidate your knowledge. If you prefer, you can...

B1P-6

B1P-6 | NX Tutorial Modeling Position sketch, Combine bodies in extrude, Mirror in sketchCombine bodies? Until now, all bodies were created in a single step. But this exercise requires the body to be created over multiple steps.That is, for the first time, the part is...

B1P-9-2

B1P-9-2 | NX Tutorial Modeling Thread, Sketch blocks, Extrude with offset.Next level ... In this second building stage, you will create the thread, and thus get to know the extensive setting options of the command of the same name. With sketch blocks from the reuse...

B1P-13-1

B1P-13-1 | NX Tutorial Modeling Extrude with internal sketches, Naming features and objectsInternal or external? What works for holes must also work for the Extrude command: This refers to internal sketches with which the Hole command works. However, these can also be...

B1P-15-A

B1P-15-A | NX Tutorial Modeling Sketch, rotate, extrude, Datum planes, Pattern featuresA typical shaft ... Are you able to design this part now? In 9 minutes? (9=very fast, 12=fast, 15=OK)Welcome to the next "Test yourself"! In this additional course several previous...

B1P-24

B1P-24 | NX Tutorial ModelingRevolve sketch (with multiple contours), Extrude until selected, Check number of bodiesControl number of bodies... The course shows new possibilities, but also problems, in selecting sketches (with multiple contours) for the revolve...

B1P-25

B1P-25 | NX Tutorial Modeling Combine extrude and revolve, Sketching with reference curves, Curve selectionPractice makes perfect The course combines once again the already learned commands and sequences on the base of a new task. In the first sketch, reference...

B1P-26-A

B1P-26-A | NX Tutorial Modeling Auxiliary geometries, save time with snap options, Curve RuleBecome even faster... Are you able to design this part now? In 5 minutes? (5=very fast, 7=fast, 10=OK) This additional course deals with auxiliary geometries in sketches and...