B1P-9-3 | NX Tutorial Modeling Edge blend, Create relations immediately, Combining sketches and edgesOops, what's that? In the third construction stage, only small things are actually missing. For example, the edge blend at the base of the socket. But the distance...
sketch
B1P-4
B1P-4 | NX Tutorial Modeling Correcting sketch, set and relax relations, trimming in the sketchChanges and even more changes ... On the one hand, it does not always work as well as in a training video, i.e. one or the other end point in the sketch is not exactly on...
B1P-25
B1P-25 | NX Tutorial Modeling Combine extrude and revolve, Sketching with reference curves, Curve selectionPractice makes perfect The course combines once again the already learned commands and sequences on the base of a new task. In the first sketch, reference...
B1P-19
B1P-19 | NX Tutorial Modeling Sketching with reference curves (auxiliary geometries), Create arcs in the sketch, Position coordinate systemsReference curves... Sometimes, auxiliary geometries are needed to create the required dimensioning or relation. NX calls such...
B1P-6
B1P-6 | NX Tutorial Modeling Position sketch, Combine bodies in extrude, Mirror in sketchCombine bodies? Until now, all bodies were created in a single step. But this exercise requires the body to be created over multiple steps.That is, for the first time, the part is...
B1P-26-A
B1P-26-A | NX Tutorial Modeling Auxiliary geometries, save time with snap options, Curve RuleBecome even faster... Are you able to design this part now? In 5 minutes? (5=very fast, 7=fast, 10=OK) This additional course deals with auxiliary geometries in sketches and...
B1P-9-A
B1P-9-A | NX Tutorial Modeling Revolve, Mirror feature, Combine sketches and edgesCheck you knowledge... Welcome to the next "Test yourself"!This exercise does not teach any new content, but rather gives you the opportunity to review and consolidate your knowledge. If...
B1P-5-A
B1P-5-A | NX Tutorial Modeling Arcs in the sketch, extrude, hole and edge blendWelcome to the second "Test yourself"! This exercise does not teach any new content, but rather gives you the opportunity to review and consolidate your knowledge. If you prefer, you can...
B1P-5
B1P-5 | NX Tutorial Modeling Arcs in the sketch, the Extrude command and Fine threadThe Extrude command ... The exercise has the following main points: The outer contour, like the long hole, consists of degrees and arcs that can be created with the Profile command ......
B1P-3-3
B1P-3-3 | NX Tutorial ModelingPart Navigator, change sketch, and change holeThe Part Navigator appears first time ... Again it is about creating variants of existing parts and the desired geometry changes. In this case, the hole loses its reference point, but the...