FF-1-P | Siemens NX - FreeformSwept, create an elbow This exercise shows the typical work steps for creating a pipe elbow with the Swept command and modelling the flanges. It is the practical exercise for the FF-1 learning video, so it does not teach you any new...
sweep along guide
Freeform
FF-1 | Siemens NX - FreeformFreeform modelling with NX Even if it's called freeform, there are still rules to follow. Whether you are designing an iron, a shampoo bottle or the wing of a turbine, there are always a lot of constraints that need to be taken into...
B1P-35
B1P-35 | NX Tutorial Modeling Curves 4, Sketch on path, Sweep along guideSketch on path ... In the two previous courses, the Tube command was used to draw a circular cross-section along another path of any shape. This created the body. With the command Sweep along...
B1P-36
B1P-36 | NX Tutorial Modeling Curves 5, Open sketches on path, Sweep along guideCurves along curves ... You can also work with an open contour train using the sweep along guide command. The open contour train is again created as a sketch on path. When the guide curve...