FF-3 | Siemens NX - FreeformSwept, orientation methods The Orientation option controls the orientation of the cross-section to the guide curve.Similar to how a spatula is repeatedly oriented differently when drawing, the different options create different surfaces.The...
swept
FF-2-P
FF-2-P | Siemens NX - FreeformSwept, create a Y-Pipe in a few minutes This exercise shows the typical work steps for creating a Y-pipe with the Swept command and modelling the flanges. It is the practical exercise for the FF-2 learning video. It shows once again the...
FF-1-P
FF-1-P | Siemens NX - FreeformSwept, create an elbow This exercise shows the typical work steps for creating a pipe elbow with the Swept command and modelling the flanges. It is the practical exercise for the FF-1 learning video, so it does not teach you any new...
B1P-40-E
B1P-40-E | NX Tutorial Modeling Construct this perfect spring with Wrap and unwrap a curveThe perfect spring ... This last expert course shows further possibilities for creating, controlling and orienting curves in 3D space. A simple compression spring with a...
FF-2
FF-2 | Siemens NX - FreeformSwept, from round to rectangular with alignment How to connect completely different sections? How to connect sections with different numbers of curves? This is where the Alignment option comes in, with its many possibilities! For example,...
Freeform
FF-1 | Siemens NX - FreeformFreeform modelling with NX Even if it's called freeform, there are still rules to follow. Whether you are designing an iron, a shampoo bottle or the wing of a turbine, there are always a lot of constraints that need to be taken into...