Siemens NX Surface: Swept, create a Y-Pipe
Course content
ff-1
Siemens NX Surface: Swept basics
07:59 Min
ff-1-p
Siemens NX Surface: Swept basic, exercise
08:28 Min
ff-2
Siemens NX Surface: Swept, from round to rectangular with alignment
08:58 Min
ff-2-p
Siemens NX Surface: Swept, create a Y-Pipe
09:52 Min
ff-3
Siemens NX Surface: Swept, orientation methods
07:05 Min
ff-3-p1
Siemens NX Surface: Swept, Helix, Face Blend
10:28 Min
ff-3-p2
Siemens NX Surface: Swept with spine, helical curve, bridge curve
10:45 Min
ff-4
Siemens NX Surface: The connection types G0, G1, G2, G3
08:27 Min
ff-5
Siemens NX Surface: Surface analysing
14:59 Min
ff-6
Siemens NX Surface: Create a perfect studio spline
13:06 Min
ff-7
Siemens NX Surface: Studio Spline in the sketch, to create Through Curve Mesh
11:51 Min
ff-8
Siemens NX: How to create Law Curves
PREMIUM
24:05 Min
ff-9-1
Siemens NX Surface: Create Through Curve Mesh surface
PREMIUM
21:03 Min
ff-9-2
Siemens NX Surface: Working with Law Extension
PREMIUM
27:30 Min
ff-9-3
Siemens NX Surface: How to link a common design surface.
PREMIUM
17:05 Min
ff-9-4
Siemens NX Surface: Rendering / Visualisation
PREMIUM
20:55 Min
About this lesson
Create all necessary steps, learn more about alignment
This exercise shows the typical work steps for creating a Y-pipe with the Swept command and modelling the flanges. It is the practical exercise for the FF-2 learning video. It shows once again the sensible segmentation of the sketch, and the alignment via points in the Swept command to create the perfect Y-pipe. As always with practical tips. You know, practice makes perfect.